My Cart: 0 item(s)

Product Search

Secure Checkout
Injector Dynamics ID1000CC for Subaru BRZ Scion FR-S 2013+
    Injector Dynamics ID1000CC for Subaru BRZ Scion FR-S 2013+
    Purchase Injector Dynamics ID1000CC for Subaru BRZ Scion FR-S 2013+
    • SKU: 271901995601
      Injector Dynamics ID1000CC for Subaru BRZ Scion FR-S 2013+

    • $480.00

    •  

    (Guaranteed Authentic & Full Warranty)

    Nominal Dynamic Flow Rate
     - 1015cc/min @ 3.0 Bar (43.5 psi) Using Gasoline at 52 Degrees C (125 Degrees F)
    Maximum Differential Fuel Pressure - 7.0 Bar (101.5 psi)
    Fuel Compatibility - Compatible With All Known Fuels
    Electrical Connector - USCAR

    ID1000, for Subaru BRZ 2013+ and Scion FR-S 2013+ 2.0L applications.
    Denso lower & 11mm machined top.
    Set of 4 injectors.
    (will require 8mm fuel rail spacer for proper fitment, not included)

    Product Code: 1000.48.11.D.4

    This kit includes:
    4x Injector Units and the install kits

    • Injector Dynamics fuel injectors are the result of batch testing large quantities of specially modified fuel injectors, and then carefully matching them to within 1%, in sets based on their dynamic flow across the pulse width range. The result is vastly superior cylinder to cylinder consistency, even at very low pulse widths. 
       
    • In addition to receiving tightly matched injectors, you will be provided with dead time compensation values across the entire pressure and voltage range of the injector. This data will insure that the compensations in your ECU work properly, and your air fuel ratios will remain consistent as atmospheric or voltage conditions change.
       
    • With pressure capability in excess of 8 bar this injector has found a home in many different applications. 
       
    • The ID1000 will maintain strict linearity at flow rates that will satisfy idle and cruise requirements for engines. If you're unsure if these will work in your application, give us a call and we'll help you figure out what it will take

    Fitment
    Application specific fitment is handled with the addition of various top hat adapters, and occasional machining operations. Standard fitment exists for most popular applications. All standard lengths and fuel rail bores are currently accommodated.

    Dynamically Matched Sets
    ID only sell matched sets, and within each set the dynamic flow rate (slope) will vary no more than +/- 1%, and the dead time (offset) will vary no more than +/- 20 microseconds which is equivalent to +/- 1% at a pulsewidth of 2 milliseconds.

    It is this dynamic flow matching across the pulse-width range that separates the men from the boys.

    Tight matching at low pulse widths allows the use of high flow rate injectors without sacrificing idle, off idle, and cruise quality while the matched offsets insure that the individual injectors respond properly to atmospheric and voltage compensations built in to the ECU.


    Full Dynamic Characterization
    ID provide the data that you and your ECU need to do the job properly.

    Flow and offset values are provided from 8 to 16 volts across the full pressure range in 5 psi increments.

    Additionally, ID publish full dynamic characterization curves: Raw flow vs pulse width, offset corrected flow, linearity curves, and pressure sensitivity plots.



    Important Shipping NOTICE: Posted shipping cost ONLY applies for lower 48 states. Shipping to HI/PR/AK/VI/GU may cost more. Please contact us before you place any order. Thank you.